Hide Table of Contents

Selecting End Conditions for Extruded Features

You can right-click anywhere on an extruded feature and change the end condition from a shortcut menu. You can click in empty space, on geometry, or on the handle.

The shortcut menu provides all the options for Direction 1 and Direction 2, and is available for the following features:
  • Extruded Boss/Base
  • Revolved Boss/Base
  • Extruded Cut
  • Revolved Cut
  • Extruded Surface
  • Revolved Surface
  • Sheet Metal Base Flange

Previously, you could only enable Direction 2 from the PropertyManager. Also, if both directions were enabled, you had to right-click the appropriate handle to set that direction’s end condition.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Selecting End Conditions for Extruded Features
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.48