Hide Table of Contents

Adding a Slope

To add a slope to a pipe route:

  1. Open a routing assembly and click Piping > Edit Route tool_piping_edit_route.gif (Routing toolbar).
  2. Right-click the sketch entity at the location where you want to add the slope and select Add Slope add_slope_button.

    The Pipe Slope PropertyManager appears.

  3. Select the Gravity Plane.

    The pipe segment must be on that plane.

  4. Select a Start Point.

    The start point must be a fixed point that the pipe segment can use to rotate and create the slope.

  5. In the PropertyManager, enter the rotation angle of the Slope, expressed as a ratio.
  6. Click PM_OK.gif.

The slope is added to the pipe segment.

You can edit the slope by selecting the route segment and right-clicking Edit Slope edit_slope_button . To remove the slope, right-click the segment and select Remove Slope remove_slope_button. You can also annotate slopes in drawings and BOMs.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Adding a Slope
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.