Hide Table of Contents

Revolved Surface

Choose different sketches from intersecting or non-intersecting sketches to create the revolve with the Selected Contours pointer .

Non-intersecting profiles Selected Contours
Intersecting profiles Selected Contours

To create a revolved surface:

  1. Sketch a profile and a centerline around which to revolve the profile.

  2. Click Revolved Surface (Surfaces toolbar) or Insert > Surface > Revolve.
  3. Set the PropertyManager options.
  4. Click OK .

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Revolved Surface
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.