Hide Table of Contents

Define Study Name

The Define Study Name dialog box allows you to create a new study by duplicating the current study and associate the new study with any of the existing configurations.

Study Name Type a name for the study.
Configuration to use Select the desired configuration from the list.
Convert to a nonlinear dynamic study Available for nonlinear static studies only. Select this option to create a new nonlinear dynamic study that has the same definitions (study properties, fixtures, loads, mesh) with the current nonlinear static study. Make sure to define damping parameters before you run the nonlinear dynamic study.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Define Study Name
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46