Hide Table of Contents

Advanced Fixtures for 2D Simplification Studies

Symmetry

Restrains the selected edge from moving along the in-plane normal direction to the edge. This option is similar to the Roller/Slider options.

Use Reference Geometry

Use a reference geometry to apply restraints. The reference can be a face or plane parallel to the section plane, or axis, or to an edge. The table shows the translations and rotations not applicable along certain directions.

Reference geometry Translations Rotations
Face or plane parallel to section plane

- Normal to plane

- Along Plane Dir 1

- Along Plane Dir 2
Edge   You cannot apply rotations
Axis on the section plane

- Circumferential

 You cannot apply rotations
Axis normal to the section plane (not allowed for the axisymmetric type) - Axial

 - Radial

- Circumferential



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Advanced Fixtures for 2D Simplification Studies
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46