Hide Table of Contents

Starting the Copy Settings Wizard

You can launch the Copy Settings Wizard from the Tools > Save/Restore Settings in the SolidWorks software or click Start > All Programs > SolidWorks version > SolidWorks Tools > Copy Settings Wizard .

When you start the wizard from the SolidWorks software, the wizard runs in a special mode which allows the SolidWorks software to remain up and running, while you save or restore your current user settings.

If you start the wizard from the Start menu, you can save settings while SolidWorks is running but any options set during the current session are not saved. Also, if you are restoring settings, ensure that the computer or user to which you are restoring settings is not running SolidWorks.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Starting the Copy Settings Wizard
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21