Hide Table of Contents

Adding Middle Components to a Hole Series

In this example, you created a hole series with the middle component suppressed. Now you want to include the middle component in the hole series.

To add middle components to a hole series:

  1. In the FeatureManager design tree, right-click the middle component and select Set to Resolved.

    The middle component appears but is not included in the hole series.

  2. In the FeatureManager design tree, right-click the hole series feature and select Edit Feature.
  3. Select the Hole Series (Middle Parts) tab to open the PropertyManager.
  4. Expand New Component(s) to add the middle component to the hole series.
  5. Click .



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Adding Middle Components to a Hole Series
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21