> Parts and Features > Reference Geometry > Reference Points > Creating Single Reference Points

Introduction

Administration

User Interface

SolidWorks Fundamentals

Design Studies in SolidWorks

Detailing and Drawings

Display States in Parts

Center of Mass Points

Coordinate Systems

Conversion of Sketch Lines to Construction Geometry

Reference Points

Creating Single Reference Points

Creating Multiple Reference Points Along Curves

Point PropertyManager

Updating Reference Geometry in Document Templates

Sustainability Products

Creating Single Reference Points

To create a single reference point:

Click Point on the Reference Geometry toolbar, or click Insert > Reference Geometry > Point.
In the PropertyManager, select the type of reference point to create.
In the graphics area, select the entities to use to create the reference point.
Click .

Parent topic

Reference Points

Related reference

Point PropertyManager

Search 'Creating Single Reference Points' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Creating Single Reference Points
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

This topic and all topics linked from this topic

Just this topic

This topic and only immediate topics under it

This selected topic and all subtopics

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.