> SolidWorks Utilities > SolidWorks Utilities > Symmetry Check Utility > Symmetry Check > Checking for Symmetry in Parts (Manual Face Check)

Introduction

Administration

User Interface

SolidWorks Fundamentals

Design Studies in SolidWorks

Detailing and Drawings

Sustainability Products

Find and Replace Annotation

Symmetry Check Utility

Checking Assembly Symmetry

Checking Part or Assembly Symmetry About a Selected Plane

Symmetry Check

Symmetry Check Results - Parts Examples

Checking for Symmetry in Parts (Manual Face Check)

Checking for Symmetry in Parts (Automatic Symmetry Split)

Feature Parameter vs. Volume-based Feature Simplification

Checking for Symmetry in Parts (Manual Face Check)

To check for symmetry in parts:

Click Symmetry Check (Tools toolbar) or Tools > Symmetry Check.
In the PropertyManager, select Manual Face Check.
Set the Analysis parameters.
Click Check.
View the Symmetry Check results.
Save a report, click Recheck to run a new symmetry check, or click .

Parent topic

Symmetry Check

Search 'Checking for Symmetry in Parts (Manual Face Check)' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Checking for Symmetry in Parts (Manual Face Check)
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

This topic and all topics linked from this topic

Just this topic

This topic and only immediate topics under it

This selected topic and all subtopics

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.