Hide Table of Contents

Creating Iso-Surface Plots

To create iso surfaces of the active plot:

  1. Activate the desired plot by double-clicking on its icon in the Simulation study tree.
  2. Right-click the plot icon and select Iso Clipping or click (Simulation Result Tools toolbar).
  3. In the PropertyManager, under Iso 1, type a value for Isovalue or drag the slider to specify the desired iso value.

    The plot updates to show surfaces with values greater than the Isovalue.

  4. To view surfaces less than the Isovalue, click Reverse clipping direction .
  5. To further modify the plot, select Iso 2, specify an Isovalue, and click Reverse clipping direction if necessary.

    You can repeat the previous step to define up to 6 isovalues.

  6. Under Options:
    1. Click Reset to reset the values in the PropertyManager to the initial state.
    2. Click Clipping on/off to turn the clipping of the current plot on or off.
  7. Click .


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating Iso-Surface Plots
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46