Hide Table of Contents

Sketch Picture PropertyManager

The Sketch Picture PropertyManager includes two pages, accessed by PM_back.gif and PM_next.gif.

From the Sketch Picture PropertyManager you can:
  • Insert sketch pictures onto either side of a sketch plane, and control the transparency of images.
    Use transparency when two images occur on parallel planes to control the display of each image. Sketch picture transparency is not supported when the transparency intersects a second sketch picture that also includes transparency.
  • Convert raster data to vector data, and create features from the sketched vector data.

Contents

  • Sketch Picture PropertyManager: Page 1

    The first page of Sketch Picture PropertyManager controls the picture's position, size, angle, orientation, aspect ratio setting, and transparency.

  • Sketch Picture PropertyManager: Page 2

    The second page of the Sketch Picture PropertyManager enables you to trace outlines or select areas by color to create vector data. This creates a sketch that you can save and edit as needed.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Sketch Picture PropertyManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46