Hide Table of Contents

Insert Image

Inserts images into reports. Images that you insert capture the current state of the model, mesh, or results.

If any of these change, these images do not update the next time you publish the report.

To access this PropertyManager, do one of the following:

  • In the Simulation study tree, right-click a report and click Include Image.
  • Click Include Image for Report (Simulation CommandManager).

After you click , an image appears in the Simulation study tree under the selected reports and in the Images folder under Report. The report section associated with the image appears in parentheses after the image name.

You must publish the report to see the new images in the report.

Image Type

  Current View Inserts the current image of the model in the graphics area, a mesh plot, or a result plot.
  Image file Lets you select a .bmp, .gif, or .jpg file.

Include in Report

  Report Name Lets you select the reports to include the image.
  Section Sets the section of the report where you want to include the image.

Properties

  Caption Appears under the image and in the list of figures.
  Comments Appears under the caption of the image.

Annotations

(Available when Current View is selected.)

Lets you specify which load, fixture, or connector annotations to include in the image. The annotation information is derived from the definition of the corresponding load, fixture, or connector.

You can move an annotation by dragging it.
  Feature Name Displays the selected annotations in the graphics area.
  Highlight feature entities Shows all feature entities that define the loads, fixtures, and connectors.
  Hide all symbols Hides the load, fixture, and connector symbols.

Options

(Available when Current View is selected.)

Orient the model and zoom to the desired scale before clicking to add the image.
Model View Captures the current view in the graphics area.
Mesh View Captures the selected mesh plot from the list. This option is available only if a mesh exists. If no mesh plots exist, the software creates an image of the meshed model. To see the plot in the graphics area, click Activate.
Result Plots Captures the selected result plot from the list. This option is available only if results exist. To see the plot in the graphics area, click Activate.

Insert an Image in All Reports

To insert an image in all reports, in the Images folder, right-click the image and click Include in All Reports.

Remove an Image from a Report

  • To delete an image from a report, right-click the image and click Remove from Report.
  • To delete an image from the Images folder and all reports simultaneously, in the Images folder, right-click the image and click Delete.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Insert Image
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.