Hide Table of Contents

Solution Procedures for Nonlinear Problems

For nonlinear problems, the stiffness of the structure, the applied loads, and/or boundary conditions can be affected by the induced displacements. The equilibrium of the structure must be established for a deformed shape which is unknown and must be guessed. At each equilibrium state along the equilibrium path, the resulting set of simultaneous equations will be nonlinear. Therefore, a direct solution will not be possible and an iterative method will be required.

Several strategies have been devised to perform nonlinear analysis. As opposed to linear problems, it is extremely difficult, if not impossible, to implement one single strategy of general validity for all problems. Very often, the particular problem at hand will force the analyst to try different solution procedures or to select a certain procedure to succeed in obtaining the correct solution (for example, "Snap-through" buckling problems of frames and shells require deformation-controlled loading strategies such as displacement and arc-length based controls rather than Force-controlled loading).

For these reasons, it is imperative that a computer program used for nonlinear analyses should possess several alternative algorithms for tackling wide spectrum of nonlinear applications. Such techniques would lead to increased flexibility and the analyst would have the ability to obtain improved reliability and efficiency for the solution of a particular problem.

Concept of Time Curve

For nonlinear static analysis, the loads are applied in incremental steps through the use of "time" curves. A time curve prescribes how a load or a restraint changes during the solution steps. For nonlinear dynamic analysis, and nonlinear static analysis with time-dependent material properties (e.g., creep), "time" represents the real time associated with the loads' application.

The choice of "time" step size depends on several factors such as the level of nonlinearities of the problems and the solution procedure. A computer program should be equipped with an adaptive automatic stepping algorithm to facilitate the analysis and to reduce the solution cost.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Solution Procedures for Nonlinear Problems
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.