Hide Table of Contents

Bill of Materials for Routing Assemblies

When you create a BOM (Bill of Materials) for a route assembly, you can select a template that causes each unique cut length of pipe to be listed as a separate item. The template also assigns part numbers based on a configuration-specific property.

Otherwise, inserting and editing a BOM is the same as it is with other types of assembly drawings.

You can add a BOM to a routing assembly or to a selected drawing view for the routing assembly.

You can insert a table-based Bill of Materials or an Excel-based Bill of Materials in a drawing, but not both.

Create the template for the Routing Assembly BOM before you include the BOM with the assembly or drawing view.

Contents



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Bill of Materials for Routing Assemblies
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46