Hide Table of Contents

Adding a Connection Point

To add a connection point:

  1. Create a sketch point to use for locating the connection point.

    The location of the connection point defines the end of the adjoining routing segment; that is, the point where the pipe, tube or wiring begins or ends.

  2. Click Create Connection Point tool_Connection_Point_Routing.gif (Routing Tools toolbar) or Routing > Routing Tools > Create Connection Point .

    To create a connection point on a cylindrical feature, select the flat face of the feature. You do not need to create a sketch point first.

    The Connection Point PropertyManager appears.

  3. Edit properties in the PropertyManager.
  4. Click PM_OK.gif.
Repeat this process for fittings that support multiple CPoints, and for assemblies that need assembly connection points (ACPoint).


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Adding a Connection Point
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21