Hide Table of Contents

Customizing Connector Tables

Routing connector tables are general tables defined by .slbomtbt templates. Generate a custom connector table from a valid custom connector table template or modify the connector table generated by the default template. You must retain the default connector table columns in custom connector tables.

To create a custom connector table:

  1. Create a connector table from a valid connector table template:
    1. Do one of the following:

      • From the Flattened Route PropertyManager, select Drawing Options, select Connector table.
      • From a flattened routing assembly, click Insert > Tables > Electrical Tables > Connector Table.

    2. If your connector table template is not selected, click Open Table Template PM_Table_Browse_Template.gif to select it, and click .
  2. Create a connector table from a valid connector table template:
    1. Do one of the following:

      • From the Flattened Route PropertyManager, select Drawing Options, select Connector table.
      • From a flattened routing assembly, click Insert > Tables > Electrical Tables > Connector Table.

    2. If your connector table template is not selected, click Open Table Template PM_Table_Browse_Template.gif to select it, and click .
  3. Modify the table as required.

    You must retain the Pin, Wire Name, and Color columns in the connector table.

    For information on customizing table templates, see Solidworks Help: Custom Table Templates.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Customizing Connector Tables
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21