Hide Table of Contents

Inserting Electrical Tables into a Drawing When You Flatten a Route

To insert electrical tables into a drawing when you flatten a route:

  1. Click Flatten Route Tool_FlattenRoute_Electrical.gif (Electrical Routing toolbar) and select Drawing Options:
    • Click Electrical BOM, and select a template.
    • Click Cut list and select a template.
    • Click Connector table and select a template.
    • Click Auto balloons to include them.
  2. Set other options in the PropertyManager.
  3. Click PM_OK.gif.
You can also create electrical tables for a flattened route by right-clicking the flattened route and selecting Edit Flattened Route.
Balloons are not created for cables or wires.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Inserting Electrical Tables into a Drawing When You Flatten a Route
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46