Hide Table of Contents

Rebuild and Save Settings Dialog Box

In this dialog box, you can specify the configurations to which you want to apply the Rebuild/Save mark.

To open this dialog box:

  • At the top of the ConfigurationManager or FeatureManager design tree, right-click the model name, click Rebuild/Save Mark, and click Add Mark for Specified Configurations.
Specify configurations to rebuild Applies the Rebuild/Save mark cfgmgr_blue_save_disk.png to the active configuration and any other configurations that you select from the list. The selected configurations have full data sets generated the next time you save the document. Subsequently, the data is rebuilt and saved every time you save the document.

Also, removes the Rebuild/Save mark cfgmgr_blue_save_disk.png from all other configurations, and changes their icons to cfgmgr_checkmark_gray.gif or cfgmgr_dash_gray.gif (depending on the current state of their configuration data).

Select All Selects all the configurations listed.
Reset Selection Reverts to the active configuration.
When the model is opened in Service Pack 5 of the previous release of SolidWorks:
  • Configurations marked with the Rebuild/Save mark cfgmgr_blue_save_disk.png are available.
  • Configurations without the mark are not available.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Rebuild and Save Settings Dialog Box
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.