Hide Table of Contents

Inserting Center Marks Manually

To insert center marks manually:

  1. Click Center Mark Tool_Center_Mark_Annotation.gif (Annotation toolbar) or Insert > Annotations > Center Mark .

    The pointer changes to pointer_Center_Mark.gif.

  2. Under Manual Insert Options, select the center mark and set the options.
  3. Set the remaining options in the Center Mark PropertyManager.
  4. Select a circular edge, slot edge, or arc.

    You cannot apply a center mark to an ellipse or a torus.

  5. If you selected Linear Center Mark PM_Center_Mark_Linear.gif or Circular Center Mark PM_Center_Mark_Circular.gif, click Propagate Propagate.gif to apply center marks to all entities in the pattern.
  6. Click PM_OK.gif.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Inserting Center Marks Manually
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.24