Hide Table of Contents

Editing Sensors

To edit a sensor:

  1. In the FeatureManager design tree, in the Sensors folder, right-click a sensor and select Edit Sensor.

    If the Sensors folder is not visible, right-click the FeatureManager design tree and select Hide/Show Tree Items. Then in the dialog box, select Show in Sensors.

  2. Change parameters in the Sensor PropertyManager.
  3. Click .

    The sensor and its current value appear in the Sensors folder in the FeatureManager design tree.

You can double-click a sensor in the FeatureManager design tree for more information about it. For example:
  • Double-click an Interference Detection sensor. The Interference Detection PropertyManager opens and the graphics area zooms to the interference.
  • Double-click a Mass Properties sensor. The Mass Properties dialog box opens.
  • Double-click a Dimension sensor. The graphics area zooms to the dimension.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Editing Sensors
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.