Hide Table of Contents

Setting Options for Center Marks

To set options for center marks:

  1. Click Options Tool_Options_Standard.gif, and select Centerlines/Center Marks from the Document Properties tab.
  2. Under Center marks:
    1. Type a value for Size. Size controls the length the center mark extends past the model edge and the size of the point symbol in the center.
    2. Select or clear the check boxes for Extended lines and Centerline font.
  3. Under Slot center marks, select Orient to slot or Orient to sheet and select a slot center mark location option. These settings determine how straight and curved slots are created.
  4. Select Detailing from the Document Properties tab. Under Auto insert on view creation, select or clear the check box for:
    • Center marks - holes -part
    • Center marks - fillets -part
    • Center marks - slots -part
    • Center marks - holes -assembly
    • Center marks - fillets -assembly
    • Center marks - slots -assembly

    When selected, center marks are inserted automatically into all appropriate circles, arcs, and fillets in new drawing views.

  5. Click OK.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Setting Options for Center Marks
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.