Hide Table of Contents

Sketching Parallelograms

To sketch parallelograms:

  1. Click Parallelogram Tool_Parallelogram_Sketch.png.
  2. In the graphics area:
    1. Click to define the first corner.
    2. Drag, rotate, and then release to set the length and angle of the first edge.
    3. Click, rotate, and drag to set the angle and length of the other three edges.
    4. Release to set the four edges.

    Video: Sketching Parallelograms

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Sketching Parallelograms
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.