Hide Table of Contents

Exporting Settings for a SolidWorks Sustainability Study

You can expand the Life Cycle Assessment (LCA) analysis of your products by saving the settings for a SolidWorks Sustainability study to the GaBi® Life Cycle Assessment Software (produced by PE INTERNATIONAL).

To save the settings:

  1. At the bottom of the Environmental Impact section of the Sustainability task pane, click Save As sustainability_save_as_button.png.
  2. In the Sustainability Output dialog box, for File type, select GaBi input file.

    The File name and Save file to fields default to the name and location of the part or assembly for which you are doing the Sustainability study.

  3. Optionally, change the File name and save location.

    Do not add an extension to the file name. The software uses the correct extension (.xml) to save the file.

  4. Click OK.

You can also use the Sustainability Output dialog box to:

  • Generate Sustainability reports.
  • Export the settings and results for a SolidWorks Sustainability study to a spreadsheet so that you can share this information without sharing the model.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Exporting Settings for a SolidWorks Sustainability Study
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.