Hide Table of Contents

Numeric Sketch Input

You can specify numeric input as you create lines, rectangles, circles, and arcs.

To enable numeric input, right-click in a sketch and click Sketch Numeric Input menu_sketch_numeric_input.gif.

You can also click Tools > Options > System Options > Sketch and select Enable on screen numeric input on entity creation

To specify numeric input:

  1. In a sketch, click Corner Rectangle (Sketch toolbar) or Tools > Sketch Entities > Rectangle .

  2. Click and release to start the rectangle, and then move the pointer.

    Fields appear for each side of the rectangle. One field is ready to accept numerical input.

  3. Type 1, and then press Tab in a 2D sketch, or Shift Tab in a 3D sketch.

    The width is set to 1 and focus changes to the other side.

  4. Type 2, and then press Enter.

    The rectangle is sized to the length you specified and the numeric fields disappear.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Numeric Sketch Input
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.