Hide Table of Contents

Selecting Units in the Find Similar Dialog Box

You can change the units that are displayed for material properties in the Find Similar dialog box.

The options available are the same as those that are available when you edit a material using the SolidWorks Materials editor.

  1. In the Material section of the Sustainability task pane, click Find Similar.
  2. In the Find Similar Material dialog box, on the right side of the Environmental Impact section, expand the Units drop-down list to select from the following:
    Option Description
    SI -N/m^2 (Pa)
    English (IPS) Inch, pound, second
    Metric (MKS) Meter, kilogram, second
    SI -N/mn^2 (MPa)  

    The changes appear in the dialog box headers and in the materials list that appears when you initiate the search for similar materials.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Selecting Units in the Find Similar Dialog Box
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.