Hide Table of Contents

Adding Sheet Metal Gussets

You can create sheet metal gussets with specific indents that go across bends.

To add sheet metal gussets:

  1. Click Sheet Metal Gusset tool_shm_gusset.png (Sheet Metal toolbar) or Insert > Sheet Metal > Sheet Metal Gusset.
  2. In the Sheet Metal Gusset PropertyManager, under Position, select:
    • The bend face or two planar faces that are adjacent to a bend.
    • The edge to be used as a reference.

      This can be any linear entity in order to specify the alignment of the gusset.

    • The point to be used for dimensioning.

      If you pick the edge you automatically get an endpoint as a reference. However, you can also choose another entity, such as a sketch point or an endpoint of a line.

      To move the gusset in relation to the selected point, check Offset and specify the offset amount.

  3. Under Profile:
    1. Do one of the following:

      • For a gusset that is symmetrical relative to the bend face, select Indent depth and specify a depth.
      • For an asymmetrical gusset, select Profile dimensions.

        Either specify the depth (d1) of one gusset leg and specify an angle (a1) or specify the depth of each gusset leg.

        To reverse the lengths of the legs, click Flip dimension sides.

    2. Select a gusset type:

      Option Button Preview Gusset
      Rounded rib Sheet_metal_gusset_flat1 Sheet_metal_gusset_rounded2 Sheet_metal_gusset_rounded3
      Flat rib Sheet_metal_gusset_rounded1 Sheet_metal_gusset_flat2 Sheet_metal_gusset_flat3

    3. If you choose Flat rib, optionally, specify an Edge Fillet.
  4. Under Dimensions:
    1. Enter a value for Indent width to specify the width of the gusset.
    2. Enter a value for Indent thickness to specify the gusset wall thickness.
    3. To specify an angle for the gusset sides, click Sheet_metal_gusset_side_face_draft and enter a value for Side face draft.
    4. Optionally, change the values for Inner corner fillet Sheet_metal_gusset_inner_corner_fillet and Outer corner fillet Sheet_metal_gusset_outer_corner_fillet. You can also disable the buttons to remove fillets.
  5. Under Preview, select one of the following:

    Partial preview Full preview
    Sheet_metal_gusset_partial_preview Sheet_metal_gusset_full_preview

  6. Click PM_OK.gif.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Adding Sheet Metal Gussets
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.