Hide Table of Contents

eDrawings Publisher for SolidWorks

Create eDrawings® part (*.eprt), assembly (*.easm), and drawing (*.edrw) files from SolidWorks part, assembly, and drawing files.

Installation

The eDrawings publisher for SolidWorks is installed with SolidWorks.

To create eDrawings files using the eDrawings Publisher for SolidWorks:

  1. Open the SolidWorks file.
  2. Click File > Publish to eDrawings (tool_Publish_eDrawing.gif in the Save flyout toolbar).

    The eDrawings Viewer appears with the published file displayed.

  3. Click Save tool_Save.gif or File > Save.
  4. In the Save As dialog box, select from the options, which vary depending on the file type.
  5. Click Save to save the eDrawings file.
    An alternative method is to click File > Save As in SolidWorks and save the document as an eDrawings document.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   eDrawings Publisher for SolidWorks
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: eDrawings 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46