Hide Table of Contents

Replacing Assembly Reference with Assembly Reference

You can change file references from an assembly to an assembly.

In this example, you replace a sheet metal assembly with a new sheet metal assembly in a drawing view. The new sheet metal assembly was created by adding a second PEM nut to the second hole in the sheet metal part.

Sheet Metal Assembly PEM Nut New Sheet Metal Assembly
17994_sheet_metal_assembly1.png 17994_sheet_metal_part_1nut.png 17994_sheet_metal_assembly2.png
  1. Open the drawing file that you saved in the previous module, sheet_metal_1_nut.SLDDRW.

    The drawing of the sheet metal assembly with one PEM nut appears.

    17994_sheet_metal_drawing_assembly_1_nut.png

  2. Click Replace Model replace_model.png (Drawing toolbar) or Tools > Replace Model.
  3. In the PropertyManager, under Selected Views, click All Views.
  4. Under New Model, browse to select install_dir\samples\whatsnew\drawings\replace_model_in_view\sheet_metal.SLDASM and click Open.
  5. Click PM_OK.gif.

    The drawing is updated to show a second nut added to assembly, but is otherwise identical to the drawing of the first sheet metal assembly.

    17994_sheet_metal_drawing_assembly_2_nut.png

  6. Save the drawing file as sheet_metal_2_nut.SLDDRW.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Replacing Assembly Reference with Assembly Reference
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46