Hide Table of Contents

Split

You use the Split tab to apply fixtures or external forces to a section of a face instead of the whole face. The Split tab divides selected faces by either projecting a sketch on the selected faces, or by intersecting faces between two touching components.
Project a sketch on a face to create a split face.
Split a face by intersection. The two bodies must have touching edges or faces. To split the top face of the plate, first select the cylindrical face as a splitting face and the plate's top face as a face to split. The plate's top face splits into two faces.

Type of Split

Sketch Splits a face by projecting a sketch on it. You can use an existing sketch or click Create Sketch to create a new sketch. The sketch and the face to split must belong to the same body.
Intersection Splits a touching face between two bodies in contact. The two bodies must have touching edges or faces.

Selection

Project Sketch Lists the sketch you selected or created.
Other Faces to Split Select the faces to split.
Splitting face (Available when Intersection is selected). Select the intersecting face.
  Single direction Projects the sketch in only one direction.
  Reverse direction Projects the sketch in the opposite direction.
  Create Split Click to split the selected faces.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Split
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.