Hide Table of Contents

Surfaces

Surfaces are a type of geometry that can be used to create solid features. Surface tools are available on the Surfaces toolbar.

You can use surfaces in the following ways:
  • Select surface edges and vertices to use as a sweep guide curve and path.
  • Create a solid or cut feature by thickening a surface.
  • Extrude a solid or cut feature with the end condition Up to Surface or Offset from Surface.
  • Create a solid feature by thickening surfaces that have been knit into a closed volume.
  • Replace a face with a surface

Contents

  • Surface Bodies

    Surface body is a general term that describes connected zero-thickness geometries such as single surfaces, knit surfaces, trimmed and filleted surfaces, and so on. You can have multiple surface bodies in a single part.

  • Surface Features

  • Surface Controls



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Surfaces
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.29