Hide Table of Contents

Find/Modify Utility

The Find/Modify utility lets you find a set of features in a part that satisfy specified parameter conditions, then edit them in a batch mode.

Find/Modify lets you:
  • Find features that belong to a specific type.
  • Find features of a specific type and satisfy specified parameter conditions. For example, you can find all simple holes less than 10mm in diameter.
  • Modify selected features from the list of found features. For example, you can change all holes less than 10mm in diameter to 5mm diameter holes.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Find/Modify Utility
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.