Hide Table of Contents

Geometry Analysis

Geometry Analysis identifies geometric entities in a part that could cause a problem in other applications. These applications include finite element modeling or computer-aided machining.

Geometry Analysis identifies the following entities:

  • sliver faces
  • small faces
  • short edges
  • knife (sharp) edges and vertices
  • discontinuous edges and faces

You can specify values of control parameters to identify these geometric entities. For example, you can specify the maximum length for short edges.

The results can be graphically analyzed with the Geometry Analysis PropertyManager that appears after the analysis is complete.

Contents



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Geometry Analysis
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.36