Hide Table of Contents

Sticky Settings

Settings in certain options persist across SOLIDWORKS sessions and versions until you change them.

Settings in certain options persist after you click OK or when you accept PropertyManager options.

The following options persist across SOLIDWORKS sessions and versions:

Knit Surface PropertyManager When you click Gap Control and type custom values for the Gap Control dialog box, the Gap Control check box and the values you enter persist.
Edge Flange PropertyManager The new settings under Flange Length and under Flange Position and the values that you enter persist.
Hole Specification PropertyManager (Hole Wizard) The settings under End Condition and the Depth values that you enter persist.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Sticky Settings
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.