Hide Table of Contents

Creating a Coordinate System With Insufficient Entities

You may need to locate a coordinate system where there are insufficient entities available to define the coordinate system. In this case, you can define a coordinate system someplace on the part or assembly that does provide the entities you need. Then you can move the new origin to the desired location. The new location must contain at least one point or vertex.

To translate a coordinate system to a new location:

  1. Click Coordinate System (Reference Geometry toolbar) or Insert > Reference Geometry > Coordinate System .
  2. Define the coordinate system at a location on the part or assembly that provides the entities you need to control the angle and direction of each axis.
  3. Click in Origin, then select the point or vertex to which you want to translate the origin.
  4. Click .

    The origin moves to the location that you selected.

    When you create a coordinate system, it is a good idea to give it a meaningful name to explain its purpose. Click-pause-click the coordinate system’s name in the FeatureManager design tree and enter a new name.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Creating a Coordinate System With Insufficient Entities
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.