> Sketching > Sketch Entities > Sketching Points

Introduction

Administration

User Interface

SOLIDWORKS Fundamentals

Design Studies in SOLIDWORKS

Detailing and Drawings

Belt/Chain PropertyManager (Sketch Blocks)

Sketching Infinite Lines

Midpoint Line

Line Properties PropertyManager - 2D

Insert Line PropertyManager - 2D

Sketching Parabolas

Conics

Sketching Points

Equidistant Points and Segments

Sketching Polygons

Equation Driven Curves

Dimensions and Relations

Sustainability Products

Sketching Points

Insert points into sketches and drawings.

To create sketch points:

Click Point (Sketch toolbar) or Tools > Sketch Entities > Point.
The pointer changes to .
Click in the graphics area to place the point.
The Point tool remains active so you can continue to insert points.

Contents

Changing Point Properties
Point PropertyManager

The Point PropertyManager controls the properties of a sketched point.

Parent topic

Sketch Entities

Search 'Sketching Points' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Sketching Points
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

Just this topic

This topic and only immediate topics under it (up to 3 topics)

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.