Hide Table of Contents

Running Geometry Analysis

To run Geometry Analysis:

  1. Click Geometry Analysis Tool_Geometry_Analysis_Utilities.gif (Tools toolbar) or Tools Geometry Analysis.
  2. In the PropertyManager, select the desired options and parameter values.

    To reset the options and values to the system defaults, click Reset All.

  3. Click Calculate to start the analysis.

    At the end of the operation, the Analysis Results section in the PropertyManager appears.

  4. Do one of the following:
    • Click Save Report to save your results in an HTML report.
    • Click Recalculate to clear the results and prepare for another calculation.
  5. Click PM_OK.gif.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Running Geometry Analysis
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.