Hide Table of Contents

Forming and Dissolving Subassemblies

You can form or dissolve a subassembly that contains suppressed components from the FeatureManager design tree or the graphics area.

When a subassembly dissolves, the components remain at the same position in the FeatureManager design tree, with folders and subfolders preserved.

You can also:

  • Select and dissolve multiple subassemblies.
  • Undo the dissolve action.
  • Form a new subassembly by right-clicking a folder in the FeatureManager design tree and clicking Form New Subassembly.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Forming and Dissolving Subassemblies
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.