Hide Table of Contents

Checking In and Checking Out Named BOMs

You can create a new version of a named BOM by checking the named BOM out, editing it, and checking it in.

To check in or check out a named BOM, you can do either:

  • On the Bill of Materials tab, select a named BOM and click Check In or Check Out .
  • In the Commands section, select Switch to BOM View BOM_UI_Switch_View, right-click a named BOM document, and select Check In (or Check Out).
In the Enterprise PDM menu bar, you can also click Actions > Check in or Actions > Check out to manage revisions of selected named BOMs.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Checking In and Checking Out Named BOMs
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS PDM 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46