Hide Table of Contents

Profile Center Mate - Supported Profiles

You can use profile center mate for these types of entities:

  • Full circular edge or face
  • Linear edge
  • Regular n-sided polygon edge or face

Rectangular profiles can have fillets, chamfers, internal cuts, or cut-off corners. You cannot use rectangles with cuts or additions to the perimeter for profile center mates.

Supported profiles
Unsupported profiles

For unsupported profiles, you can create a supported profile sketch to use in the profile center mate.

Part with unsupported profile Rectangular profile sketch mated to rectangular base using profile center mate


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Profile Center Mate - Supported Profiles
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46