Hide Table of Contents

Using Replace Entity

To replace a sketch entity:

  1. In sketch mode, click Replace Entity Tool_Replace_Entity (Sketch toolbar) or Tools > Sketch Tools > Replace.
  2. In the graphics area, select the sketch entity to be replaced.

    The PropertyManager displays the entity name.

  3. In the graphics area, select the sketch entity to replace.
  4. In the PropertyManager, select Make construction, Delete or Make contour.

    Make construction converts the entity to a construction entity. Delete removes the entity. Make contour converts the entity to a contour entity.

  5. Click PM_OK.gif.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Using Replace Entity
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46