Hide Table of Contents

Creating Cams

To create a cam:

  1. Click Cams (Toolbox toolbar) or Toolbox > Cams .
  2. In the Cam dialog box, on the Setup tab, for Cam Type, select Circular or Linear and set property values for the cam type you selected.

    You can also create a cam based on a previously saved favorite cam. See Using Favorite Cams.

  3. On the Motion tab, create at least one cam motion definition.
  4. On the Creation tab, set creation properties.
  5. Click Create.

    Toolbox creates a new cam as a new SOLIDWORKS part document.

  6. Optionally, save your cam as a favorite. See Favorite Cams.
  7. Click Done.

Contents

  • Cam - Setup

    The Setup tab of the Cam dialog box specifies basic information such as units, cam type, and follower type.

  • Cam - Motion

    The Motion tab of the Cam dialog box specifies information about how your follower moves around the cam.

  • Cam - Creation

    The Creation tab of the Cam dialog box specifies values for the cam such as blank thickness and hub diameter.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating Cams
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46