Hide Table of Contents

Mesh

When meshing fails, you have better visualization tools to display these parts which failed to mesh.

For parts which failed to mesh, you can launch the Mesh Failure Diagnostic tool, to render these parts in shaded display mode in the graphics area. Meshed parts are rendered in wireframe display mode.

Click Show bodies which failed to mesh.

Click Show mesh for all bodies to view the meshed bodies only.

You can double-click a body listed in the Mesh Failure Diagnostics pane to zoom-in the body in the graphics area.

View with active option Show bodies which failed to mesh. View with active option Show mesh for all bodies.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Mesh
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.62