Hide Table of Contents

Change to Isometric and Zoom to Fit View Mode Example (VBA)

This example shows how to change the current view mode to isometric and Zoom to Fit.




' Preconditions: Model document is open.


' Postconditions: Current view mode is changed to isometric and Zoom to Fit.



Option Explicit

Sub main()

    Dim swApp                   As SldWorks.SldWorks

    Dim swModel                 As SldWorks.ModelDoc2


    Set swApp = CreateObject("SldWorks.Application")

    Set swModel = swApp.ActiveDoc


    ' Not quite the same as when done through the user interface;

    ' model is zoomed out a bit further

    swModel.ShowNamedView2 "*Isometric", -1


    ' Now view the same as done through the user interface


End Sub


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Change to Isometric and Zoom to Fit View Mode Example (VBA)
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: API Help (English only) 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.