Hide Table of Contents

Stereographic Viewing

eDrawings supports stereographic viewing of models.

Before opening an eDrawings file, click Tools > Options. In the dialog box, on the General tab, under Performance, select 3D Stereo Viewing (enable before opening a file in eDrawings).

To turn off stereographic viewing, you must close eDrawings, then re-open eDrawings before opening an eDrawings file, and toggle the option.

To use stereographic viewing, you must have a supported monitor, graphics card, and 3D glasses. For more information, see the NVIDIA® Corporation Web site or the Advanced Micro Devices, Inc. (AMD) Web site.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Stereographic Viewing
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: eDrawings 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46