Hide Table of Contents

Configure Items - Item ID

Use the Configure Items - Item ID page to select the serial number and file data card variable used to generate unique item IDs.

To display this page:

Double-click Items.

Item Serial Number

Specifies the serial number (see Serial Numbers) from which Enterprise PDM generates unique item IDs. The default is Item Number, which is an 8-digit counter (00000001, 00000002, and so on).

  • If Item ID Variable is set, the serial number is used only if the selected data card variable has no value.
  • Select a serial number with at least one counter component to ensure unique item IDs.
  • Item IDs cannot contain backslashes (\). Any backslashes in the serial number are replaced by underscores (_) in the generated IDs.
  • Serial numbers based on add-ins are not supported as item ID generators.
  • When creating items, users can specify item IDs other than the automatically generated IDs, for example, to specify IDs from an enterprise resource planning (ERP) system.

Item ID Variable

Specifies the file data card variable from which Enterprise PDM creates item IDs. To disable mapping of item IDs to a data card variable, select <Do not read the ID from a variable>.

If a mapped data card variable has no value or mapping is disabled, Item Serial Number is used to generate the item ID.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Configure Items - Item ID
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS PDM 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.