Hide Table of Contents

Changing Draft Using DraftXpert

To change draft using the DraftXpert Change tab:

In this example, you have already applied 3deg draft to the four orange-colored faces (two faces on each side of the horizontal cylinder).



  1. In the DraftXpert PropertyManager, select the Change tab.
  2. Under Drafts to Change, select the draft items to modify for Faces to Draft . In this example, you select the two orange-colored outer faces (one each on opposite sides of the horizontal cylinder).

  3. Set a value for Draft Angle and click Change to modify the draft for the selected faces. In this example, change the draft to 10deg.
  4. Under Draft Analysis, select Auto paint to see what other faces need draft.

    To remove draft from faces, you would click Remove.

  5. Click PM_OK.gif.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Changing Draft Using DraftXpert
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46