Hide Table of Contents

Displaying the Cross Break Parameters in a Drawing

When you create a part with a cross break, the flattened view is labeled with the bend direction, bend radius, and bend angle.

To display the cross break parameters in a drawing:

  1. Click Make Drawing from Part/Assembly (Standard toolbar) or File > Make Drawing from Part .
  2. In the Sheet Format/Size dialog box, select a sheet size and click OK.
  3. From the View Palette, drag the Flat pattern view on to the sheet.

    The bend direction, bend radius, and bend angle are labeled.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Displaying the Cross Break Parameters in a Drawing
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46