Hide Table of Contents

Spotface Symbol

The spotface symbol is no longer font dependent.

ASME Y14.5 drawings use the spotface symbol to represent shallow counterbores to clean up surfaces to a specified diameter around holes. The new symbol draws the S and F as lines and arcs that are consistently sized to match the ASME standard, regardless of font or font size. The redesigned symbol replaces the old symbol within SOLIDWORKS by an update to the GTOL.SYM file.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Spotface Symbol
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

10.20.4