Hide Table of Contents

Layer Group Properties

You can view aggregated layer group properties from the Layer Properties panel.

To open the Layer Properties panel for all layers:

From the tree view, right-click Layers and click Properties.
To view the properties if an individual layer, right-click the layer and click Properties.
Name  
Number Specifies a integer label for the layer.
Material  
Type Specifies the type of layer:

Conductor apri5copperconductorlayer.gif

Dielectric apr5dieletriclayericon.gif

Start Height Specifies the height of the bottom of the layer relative to the bottom of the board.
End Height Specifies the height of the top of the layer relative to the bottom of the board.
The end height of one layer is the same as the start height of the next layer
Thickness (mm) Specifies the thickness of the layer.
The sum of the layer thicknesses defines the board thickness.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Layer Group Properties
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.