Hide Table of Contents

Summary of Thermal Boundary Conditions

Load Type Geometric Entities Reference Geometry Type Required Input
Temperature Vertices, Edges, Faces and components N/A Unit and temperature value.
Convection Faces N/A Film coefficient and bulk temperature in the desired units.
Radiation Faces N/A Unit and value of the surrounding temperature, emissivity, and view factor for surface to ambient radiation.
Heat Flux Faces and an optional vertex for thermostat location for transient studies N/A Unit and value of the heat flux (heat power/unit area). Temperature range for optional thermostat for transient studies.
Heat Power Vertices, Edges, Faces, Components, and an optional vertex for thermostat location for transient studies N/A Unit and value of the heat power. The specified value is applied to each selected entity. Temperature range for optional thermostat for transient studies.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Summary of Thermal Boundary Conditions
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.24